Manage the authentication chain - Alfresco Content Services - 23.4 - 23.4 - Ready - Alfresco - external

Alfresco Content Services
Platform
Alfresco
Product
Alfresco Content Services
Release
23.4
License

Use these instructions to add and configure the authentication chain.

  1. Open the Repo Admin Console.
  2. In the Directories section, click Directory Management.

    You see the Directory Management page.

  3. In the Authentication Chain section, specify the name of the new directory in the Name: field.
  4. Specify the authentication subsystem type from the Type: menu.
    Note:

    If you've an External authentication type, the relevant directory will always appear as the first item in the chain.

  5. Click Add.

    The new authentication chain appears in the table.

    The Authentication Chain table has the following fields:

    • Order: Use the up and down arrows to reorder the authentication chain.
    • Name: Specifies the name of the authentication chain.
    • Type: Specifies the authentication subsystem type, such as OpenLDAP, Active Directory, Kerberos, and External.
    • Enables: Specifies if authentication is enabled or not.
    • Synchronized: Specifies if the authentication chain is synchronized or not.
    • Actions: Enables you to perform specific actions on the selected authentication chain, such as:
      • Edit: Enables you to configure the authentication directories.
      • Test: Enables you to run an authentication test. To process the test request, you need a valid user name and password.
      • Reset: Enables you to reset the directory to its initial settings or default values. You will lose all changes you’ve made to this directory since it was created.
      • Remove: Removes the directory from the authentication chain list.
      • Test synchronize: Enables you to check if synchronization is configured correctly.
    Note:

    You can only edit a directory after it has been added and saved. If you haven't yet saved the entry, the only option available is Remove.

  6. To manage synchronization with all the user registries (LDAP servers) in the authentication chain, click Synchronization Settings.

    You see the Synchronization Settings page.

  7. To start the user directory sync of all users and groups, click Run Synchronize.
  8. Click Save to apply the changes you've made to the authentication chain.

    If you do not want to save the changes, click Cancel.