Modify the Settings on the General Tab - Designer - Foundation 23.1 - Foundation 23.1 - Brainware - external

Brainware Intelligent Capture Designer

Platform
Brainware
Product
Designer
Release
Foundation 23.1
License

To edit size and position of the reading zone, complete the following step.

Note: If multiple reading zones are mapped to a single data field, a candidate evaluation must take place. This usually involves learning. If you change the properties of your reading zones after the learning, you lose all trained knowledge for the extraction.
  1. In the Zone Properties dialog box, on the General tab, complete any of the following substeps.
    • In the Name field, enter a new name for the zone.
    • From the Units list, select the unit you want to use for geometric parameters, such as pixel, inch, or mm.
    • To adjust the height of the zone to the height of the page, select Fit to image height.
    • To adjust the width of the zone to the width of the page, select Fit to image width.
    • To set the distance of the reading zone to the left edge of the page, modify the value in the Left field.
    • To set the distance of the reading zone to the top edge of the page, modify the value in the Top field.
    • To set the width of the reading zone, modify the value in the Width field.
    • To set the height of the reading zone, modify the value in the Height field.
    • To enable automatic fitting, select Enable automatic fitting and then modify the values in the Left, Right, Top, and Bottom fields.
  2. If learning was processed before, repeat the training.