The line removal process removes lines from an image (lines that were purposefully part of the paper document, not streaks that were unintentionally created during scanning). To configure the line removal process, click Line removal. The Line Removal Properties dialog box is displayed.
|
Property |
Description |
|
|---|---|---|
|
Horizontal |
Enable |
Activates the horizontal line removal process. |
|
Minimum Length |
Defines the minimum horizontal line length to remove. |
|
|
Maximum Height |
Defines the maximum horizontal line thickness to remove. |
|
|
Maximum Break |
Defines the maximum number of consecutive white pixels that are considered part of a horizontal line. |
|
|
Edge Clean Factor |
Defines the number of pixels to clean up after removing a horizontal line. |
|
|
Horizontal Character Reconstruction |
Enable |
Activates the horizontal character repair process. |
|
Minimum Repair Height |
Defines the minimum horizontal character height to reconstruct. |
|
|
Maximum Repair Width |
Defines the maximum horizontal character width to reconstruct. |
|
|
Vertical |
Enable |
Activates the vertical line removal process. |
|
Minimum Height |
Defines the minimum vertical line length to remove. |
|
|
Maximum Width |
Defines the maximum vertical line thickness to remove. |
|
|
Maximum Break |
Defines the maximum number of consecutive white pixels that are considered part of a vertical line. |
|
|
Edge Clean Factor |
Defines the number of pixels to clean up after removing the vertical line. |
|
|
Vertical Character Reconstruction |
Enable |
Activates the vertical character repair process. |
|
Minimum Repair Height |
Defines the minimum vertical character height to reconstruct. |
|
|
Maximum Repair Width |
Defines the maximum vertical character width to reconstruct. |
|
When finished, click OK to return to the Image process settings dialog box.