It is a best practice to install the Hyland Bar Code Recognition software on each Disconnected Scanning workstation, even if your solution does not require bar code processing or ISIS scanning, so that some additional software tools are installed.
You must install the Hyland Bar Code Recognition software on the Disconnected Scanning workstation if you are:
-
Planning to perform bar code processing at the time of scanning without using Kofax hardware or software.
-
Planning to scan documents using an ISIS scan format.
In the unlikely event that the Hyland Bar Code Recognition software cannot be installed on the Disconnected Scanning workstation, the ISIS software tools required for Disconnected Scanning for versions of OnBase prior to OnBase 10.0 may be installed to allow an ISIS scanner to be used.
This software can be obtained from Technical Support; be aware, however, that it is recommended that the Hyland Bar Code Recognition software be used whenever possible.
The Hyland Bar Code Recognition software is available from your solution provider.