Configuring the Rimage Software on the Rimage Workstation - Document Distribution - Foundation 23.1 - Foundation 23.1 - Ready - OnBase - external

Document Distribution
Platform
OnBase
Product
Document Distribution
Release
Foundation 23.1
License

Rimage provides three programs that complete your automated solution. These are the Image Order Server, Production Order Server, and the CD label designer software. The Image Order Server software produces a CD image and verifies the existence of the files to be placed on a CD. The Production Order Server software controls the robotics of the Rimage CD Producer. The CD label designer software can be used to customize the default label files that are supplied with the Document Distribution software.

  1. Install the Rimage server per instructions supplied by Rimage. If the system was purchased from Rimage as a complete hardware/software solution, then this software should already be installed on the Rimage workstation that came with your purchase.
  2. Create a folder on the Rimage workstation for the Image and Production Order Files.
  3. Create a shared directory for temporary files (most of which are under 2K). The RimTemp folder, usually located at C:\RimTemp, is intended for this purpose.
    Note:

    The temporary folder must be shared on the network.

  4. Set up privileges to allow the Rimage server to have network access to the OnBase file server. Without this access, it will not be capable of creating back-up or export discs.
    It is a best practice to use a single network logon for the Rimage workstation to ensure that the same icons and network access privileges are always available when a disc needs to be produced.
  5. Start the Image Order Server and select View from the main menu bar, followed by Options.
  6. Configure the options on the Output tab as indicated below.

    • Normal Image File must be selected at the first drop-down menu.

    • The options on the remaining tabs of the Imager Settings and Options dialog box should remain unchanged.

  7. Start the Production Order Server and confirm proper configuration of the values at the Parameters dialog box.

    If you are writing to both CD and DVD media, the Media Type drop-down should be set to Both for proper operation.

    All other parameters should remain at their default settings.