Every time you connect to a host via RUMBA inside of OnBase, it will use whatever configuration is stored as default by RUMBA.
To setup your host configuration to be the default setting for RUMBA, the following must be done.
-
Open up RUMBA outside of OnBase.
-
Setup RUMBA to connect to the host correctly, including RUMBA's own keymapping functionality and establish a connection.
-
Once connected, logout (if necessary) and attempt to close the RUMBA application.
-
RUMBA will then ask you if you want to save this to a profile. Select No.
-
This will now set that configuration as the default and when RUMBA is used inside of OnBase, it will connect to the particular host that was just configured.