Scan Aquisition Server and Front Office Scanning settings are maintained in EpicIntegrations.config. This file was provided with the Integration for Epic installation files; it resides in the location of the Epic executables.
The following procedure describe how to configure the Scan Aquisition Server and Front Office Scanning settings in EpicIntegrations.config. Alternately, you can use EpicIntegrations Configuration to configure the file, as described under Creating a New EpicIntegrations.config File.
To manually configure settings:
-
Within the first <server> element, modify the following to map the Epic environment ID to the corresponding OnBase Web or Application Server.
Element
Description
environmentID
The Epic environment ID you want to map.
url
The Application Server URL to connect to for the specified environment ID. Both HTTP and HTTPS are allowed. You can use the server's hostname or IP address. The following formats are acceptable:
-
http://server/AppServer/service.asmx
-
http://server/AppServer/
-
http://server/AppServer
dataresource
The OnBase data source the scanning integration will use for the specified environment ID. This data source must be configured on the associated Application Server.
For example, if the environment ID is PRD, the section might look like this:
The environmentID, url, and datasource elements must be provided in the order shown. Make sure environmentID is first, url is second, and datasource is third.
Note:If the environment ID contains a <, >, or &, then the value must be enclosed in a CDATA section. For example, if the environment ID is X&Y, then the environmentID element would use the following format: <environmentID><![CDATA[ X&Y ]]></environmentID>. If you use EpicConfigFileCreator.exe, this formatting is applied automatically as needed.
-
-
Repeat for each environment ID. When you are finished, the file might resemble the following:
