The Integration for Netsmart Homecare can be installed from a command line using options available within Windows Installer. For more information, see the article on Command-Line Options in the Microsoft Support documentation: https://learn.microsoft.com/en-us/windows/win32/msi/command-line-options
When installing from the command line, the following properties can be applied to the command line to configure Integration for Netsmart Homecare settings:
|
Property Name |
Description |
|---|---|
|
NETSMART_ADDITIONAL_ARGS |
Use this property to specify any command line switches that should be applied. See Adding a Command Line Switch for more information on available command line switches. |
|
NETSMART_CITRIX_MODE_ARG |
Set this property to -citrix if the Integration for Netsmart Homecare is going to be used in a Citrix environment when running in Host Mode. |
|
NETSMART_CONNECTED_MODE_ARG |
Set this property to -connected if the Integration for Netsmart Homecare should always start on system startup. If it should not, leave this property empty. |
|
NETSMART_STARTUP_SHORTCUT |
Set this property to 1 if the Integration for Netsmart Homecare should always connect to the OnBase Application Server at startup and remain in Host Mode. |
|
SERVICE_LOCATION_DATA_SOURCE |
Set this property to the data source name (configured at the Application Server) that the Integration for Netsmart Homecare will connect to. For example, OnBase. |
|
SERVICE_LOCATION_DISPLAY_NAME |
Set this property to the display name of the service location. For example, OnBase. |
|
SERVICE_LOCATION_NT_AUTH |
Windows Active Directory or LDAP Authentication is not available in the Integration for Netsmart Homecare. |
|
SERVICE_LOCATION_SERVICE_PATH |
Set this property to the Service.asmx page of the Application Server. |