Configuring Banner Settings - Patient Window - Foundation 23.1 - Foundation 23.1 - Ready - OnBase - external

Patient Window
Platform
OnBase
Product
Patient Window
Release
Foundation 23.1
License
Note:

Because banners typically are set up at the time of installation, banner configuration is available only when OnBase Configuration runs with the -MRMSINSTALL command line switch. Make sure this switch is applied before attempting to access banner settings in OnBase Configuration.

After importing a banner template into OnBase, you must configure the banner's settings in OnBase Configuration.

To configure the banner's settings:

  1. Select Medical | User Interface Settings | Patient Window | Banner Configuration. If this option is unavailable, make sure Configuration is running with the -MRMSINSTALL command line switch.

    The Patient Window Banner Config dialog box is displayed.

  2. Type an identifier for the banner in the field provided.
  3. Click Create. The Patient Window Banner Settings dialog box is displayed.
  4. Provide the requested information as described in the following table:

    Field

    Description

    Document Type

    Select the OnBase Document Type where you imported the banner template.

    Document Name

    Select the banner template you imported.

    Banner Description

    Type a description for this banner. The description is displayed only within the Patient Window Banner Settings dialog box for administrative reference.
  5. Click Save.
  6. Repeat these steps as needed for additional banners.
  7. Click Close when finished.