Install the Brooktrout drivers - Fax Agent Installation and Setup Guide - Foundation 24.1 - Foundation 24.1 - Ready - Perceptive Content - external

To install the Brooktrout Drivers, complete the following steps.

1. On the computer where the fax board and Fax Agent service are installed, open a Command Prompt window.
2. Navigate to the \brooktrout\driver\install directory within the Fax Agent installation directory.
3. Optional: If upgrading from a Fax Agent version prior to 7.1.3, uninstall the existing driver and reinstall the driver laid down by the installer.
4. Complete one of the following substeps.
   • If you are updating a previous install of the fax board drivers, enter install -r to remove the previous installation. When the removal is finished, restart your computer, open a Command Prompt window, navigate to the installation directory, and then enter install.
   • If you have not previously installed the fax board drivers, enter install.
5. For the maximum number of PCI/cPCI hardware modules, press ENTER.
6. For the physical buffer size, press ENTER.
7. For the application buffer size, press ENTER.
8. For the machine ID, press ENTER.
9. To perform an initial reset, press ENTER.
10. To enable history, press ENTER.
11. . For configure advanced parameters, press ENTER.
12. To start the driver only with devices present, press ENTER.
13. For the Boston PCI adjustment, press ENTER. The system automatically installs the Plug and Play driver.
14. If the system detects new hardware on your system, it displays the Found New Hardware Wizard.
15. Complete the process to install the correct drivers, as defined in the Complete driver installation section. If no new hardware is detected, continue to the Change Device Manager settings section.