Run iConvert - Run iConvert - To run iConvert, complete the following steps. - Perceptive Content - iConvert for Perceptive Content Product Guide - Perceptive-Content/iConvert-for-Perceptive-Content-Product-Guide/Foundation-26.1/iConvert-for-Perceptive-Content-Product-Guide/Install-iConvert/Run-iConvert - Foundation 26.1 - Foundation 26.1

iConvert for Perceptive Content Product Guide
Platform
Perceptive Content
Product
iConvert for Perceptive Content Product Guide
Release
Foundation 26.1
License
ft:lastPublication
2026-04-16T22:10:40.294616
ft:locale
en-US

To run iConvert, complete the following steps.

  1. Stop all Perceptive Content services.
  2. Make sure all sessions are closed by verifying the IN_SC_SESSION table is empty in the source database.
  3. In an Adminstrator Command Prompt window, navigate to the Perceptive Content local bin64 directory $(IMAGENLOWLOCALDIR6)\bin64 and type inserverConvert -start to start iConvert.
    Note: If you stop and restart iConvert, the conversion process begins where it left off. If you installed iConvert as a manual service, you must complete the previous step to re-start the process.